Manifestation Window Film

Existing glazing must be appropriately marked or featured so as to make it apparent and thus avoid risk of collision because it is not properly visible. We have available to us a variety of films and manifestation designs that are not only aesthetically pleasing but conform to the current regulations.

The Workplace (Health, Safety & Welfare) Regulations 1992 state that the risk of collision with clear glazing must be avoided by using appropriate markings and it is a legal requirement to have all relevant existing glazing made impact safe and be so marked. This is incorporated into the Building Regulations BS 6262 Part 4, Safety, Human Impact. Its effect is to prevent serious injury to persons through accidental collision with glazing at work.

Every window or glazed area in a wall, partition, door or gate shall be of safety material or be protected against breakage ie. it should not break on impact or should break safely. In particular large uninterrupted areas of glazing where people might reasonably think they can walk straight through. Manifestation window film can be decorative and designs can be created to reinforce your corporate image or to get your message across.

Document M of the Building Regulations covering access to and use of buildings' states that manifestation should be at least 50 mm wide and positioned at two levels. The lower level should be between 850 mm and 1000 mm from finished floor level and the higher from 1400 mm and 1600 mm.

Products

3M™ Scotchtint™ ~ 3M™ Scotchshield™ ~ 3M™ Night Vision™ ~ 3M™ Low-E Amber™ ~ 3M™ Safety-Walk™ ~ CoolKote ~ Sunguard ~ Anglian Technical Window Films ~ Museum Films ~ Madico ~ Lumisty® ~ Solar Screen

All leading manufacturer’s films available